urmet 1098/800 Kurzanleitung Seite 22

EN
5. In case of video signal instability on the monitor despite the good wireless signal level
Live video of the NVR channels, test the Wireless band manual selection in the "Parameter" -> "Wireless
Camera" -> "Wireless Band Selection" menu, by setting one of the three available bands:
6. The NVR is set to automatically start continuous recording of the cameras assigned to the channels. Check that
the red symbol "R" appears on the monitor for each camera.
7. To access the system remotely, wire the NVR to the network and view the network parameters currently in
use on the NVR on the "Parameter" -> "Network" page. After wiring to the network, wait for approximately ten
seconds for the parameters to be assigned and appear automatically in the Parameter Network menu.
DS1098-001
22
shown on the