urmet 1098/800 Kurzanleitung Seite 21

3. Open the OSD menu of the NVR by right-clicking on the monitor and entering the administrator password
(default: 00000000), check the firmware version currently installed on the NVR on the "System" -> "Info"
menu page. If the version is not recent, the firmware of the NVR can be updated, following the instructions
provided in the complete NVR manual which can be downloaded from the Urmet website (to download the
Manual from the Site, see the QR code on the Wi-Fi kit quick guide).
4. If a camera is not automatically detected by the NVR or to add it to the system, proceed with the manual
pairing procedure in the "Parameter" -> "Wireless Camera" -> "Pair" menu, pressing the button corresponding
to the channel to be paired (see figure below) and then press the pairing button on the camera within 10s:
21
EN