urmet 1098/800 Kurzanleitung Seite 18

EN
Do not use volatile liquids (such as petrol, alcohol, solvents, etc.) or chemically treated clothes to clean the device
to prevent deformation, deterioration or scratches to the paint finish.
Hard disk
The hard disk installed in this device is sensitive to shocks, differences in temperature and vibrations. Disrespect
of these precautions can compromise correct operation of the device and cause loss of data stored on the hard
disk.
If repairs are required, it is advisable to backup all important data before taking the device to the service centre.
URMET S.p.A. is not liable for loss of stored data.
The addition of a hard disk must be performed by qualified technical personnel or by contacting the technical
assistance service.
Image recording
This device was designed to record images, not as a burglar alarm. URMET S.p.A. cannot be held liable for loss or
damage following theft sustained by the user.
Make a test recording before using the device to make sure that is working correctly. Please note that URMET
S.p.A. is not liable for loss of stored data consequent to loss or damage caused by incorrect observation
installation, use, improper use or malfunctioning of the device.
This device contains precision electronic components. Protect the device from shocks to ensure correct recording
of images.
Privacy and Copyright
The NVR (Network Video Recorder) is a device for CCTV systems. Recording of imagines is subject to the laws in
force in your country. Recording of images protected by copyright is forbidden.
Product users shall be responsible for checking and respecting all local rules and regulations concerning
monitoring and recording video signals. The manufacturing SHALL NOT BE LIABLE for use of this product not
in compliance with the laws in force.
Software upgrades
Regularly check the specific section of the manufacturer' s web site at at www.urmet.com >> Download >> Software
for software upgrades.
Firmware upgrades
Call URMET S.p.A. Customer Service for firmware upgrades.
Network installation
The factory default IP address of the NVR is DHCP.
Using the NVR Network OSD Menu, assign the NVR an IP address which hasn't been assigned to other devices
in order to prevent any network conflict.
After assigning a proper IP address to the NVR, it can be connected to the Network.
Network connection
When connecting to a remote PC (using Client Software or I.E.), remember that all video channels used by the PC
correspond to a "unicast" type connection (TCP, RTP,UDP etc).
18
DS1098-001