Rear Side; Safety Notes; Applications; Connection Of The Unit - IMG STAGELINE MPX-210BPM Bedienungsanleitung

23 MIX control for the headphone output (24) and the
GB
VU meter (2)
"PFL" (control in the extreme left position):
the pre fader level of the input channel, of which
the PFL button (12) is pressed, is monitored via
headphones and displayed by the VU meter
"PGM" (control in the extreme right position):
the current music programme is monitored ahead
of the master control (21) and displayed by the
VU meter
Note: The VU meter must be switched to the head-
phone output [selector button (3) pressed].
24 6.3 mm jack for the connection of stereo head-
phones (impedance ≥ 2 x 8 Ω)
25 Level control for the headphone output (24)

1.2 Rear side

26 Mains cable for the connection of the unit to the
power supply (230 V~/50 Hz)
27 Stereo output REC (phono jacks) for the connec-
tion of an audio recording unit; the recording level is
independent of the position of the master control
(21)
28 Stereo monitor output BOOTH (phono jacks) for
the connection of a monitor system
29 Stereo output AMP (phono jacks) for the connec-
tion of the amplifier
30 Stereo inputs LINE and CD (phono jacks) for the
channels CH 1 to CH 4 for the connection of units
with line level outputs (e. g. minidisk recorder, CD
player, cassette recorder)
31 Stereo inputs PHONO (phono jacks) for the chan-
nels CH 1 and CH 3 for the connection of turntables
with magnetic system
32 Inputs (6.3 mm jacks, bal.) for the connection of
mono microphones to the two microphone chan-
nels; connected in parallel to the XLR jacks (7) on
the front plate
33 GND connection for a common grounding point,
e. g. for the connected turntables

2 Safety Notes

This unit corresponds to the directive for electromag-
netic compatibility 89/336/EEC and the low voltage
directive73/23/EEC.
This unit uses dangerous mains voltage (230 V~). To
prevent a shock hazard, do not open the cabinet.
Leave servicing to authorized, skilled personnel
only. Furthermore, any guarantee claim expires if the
unit has been opened.
Also observe the following items in any case:
The unit is designed for indoor use only. Protect it
against humidity and heat (admissible ambient tem-
perature range 0 – 40 °C).
Do not set the unit into operation and immediately
disconnect the mains plug from the mains socket if:
1. there is visible damage to the unit or mains cable,
10
2. a defect might have occurred after a drop or simi-
lar accident,
3. there are malfunctions.
The unit must in any case be repaired by authorized,
skilled personnel.
A damaged mains cable must only be replaced by
the manufacturer or authorized, skilled personnel.
Never pull the mains plug out of the mains socket by
means of the mains cable.
If the unit is used for purposes other than originally
intended, if it is not connected or operated properly
or not repaired by authorized, skilled personnel,
there is no liability for any possible damage.
For cleaning use a dry, soft cloth, by no means
chemicals or water.
If the unit is to be put out of operation definitively, it
must be disposed of in a local recycling plant.
Important for U.K. Customers!
The wires in this mains lead are coloured in accord-
ance with the following code:
blue = neutral
brown = live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug, pro-
ceed as follows:
1. The wire which is coloured blue must be con-
nected to the terminal in the plug which is marked
with the letter N or coloured black.
2. The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured red.

3 Applications

The mixer MPX-210BPM with four stereo channels,
two mono microphone channels, and integrated beat
counter function is suitable for any desired private or
professional DJ applications.
The unit can be placed as a table top unit as well as
be installed into a console. It is suitable for rack mount-
ing (482 mm/19") as well. For rack mounting a height of
4 rack spaces (1 rack space = 44.45 mm) is necessary.

4 Connection of the Unit

Prior to the connection of units or changing of existing
connections, switch off the mixer.
1) Connect the stereo audio sources to the corre-
sponding phono input jacks of channels CH 1 to
CH 4 (white jack L = left channel; red jack R = right
channel):
- units with line level output (e.g. mindisk recorder,
CD player, cassette recorder) to the jacks CD
and LINE (30);
- turntables with magnetic system to the PHONO
jacks (31).
The clamping screw GND (33) can be used as
common grounding point: connect the grounding
connection of the turntable to the clamping
screw.