Technical Data; Installation Instructions - Climadiff CLS40 Gebrauchsanweisung

3. TECHNICAL DATA

Below is an example of the nameplate:
The nameplate attached to the inside or rear of the appliance (depending on the model) includes the
entire information specific to your appliance.
We recommend that you make a note of its serial number in this booklet prior to installation, so that
you can refer to it later (technical work, request for assistance, etc.).
Once the appliance is installed and loaded, access to it is not so easy.
CAUTION: no assistance can be provided without this information.

4. INSTALLATION INSTRUCTIONS

Before using this appliance
 Remove the exterior and interior packing.
 Before connecting the appliance to the power source, let it stand upright for approximately 24
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
 Clean the interior surface with lukewarm water using a soft cloth.
 When disposing your appliance, please choose an authorized disposal site.
 Place your wine cooler on a floor that is strong enough to support it when it is fully loaded. To level
your Wine cooler, adjust the front leveling leg at the bottom of the wine cooler.
 Adequate ventilation is required, do not block the front air outlet.
 The appliance is designed to be free standing only.
 Not designed for placement in adage or basement.
 The appliance is for indoor use only.
 This appliance is intended to be used exclusively for the storage of wine.
 This appliance is using flammability refrigerant. So never damage the cooling pipe work during the
transportation.
33