Preparing For Use; Tips For Use; Use; Manually Adjustable Sections - Auping Automat 333 Gebrauchsanweisung

3.3 Preparing for use

Check that the mesh base can move freely.
Only adjust the mesh base while it is in a hori-
zontal position, securely fixed to the support-
ing legs, or to the supports provided within the
bed surround.
Check that the mattress is attached to the
mesh base properly.

3.4 Tips for use

A new mattress has a certain amount of rigid-
ity, which will disappear within a few days.
Consequently, your mattress will not optimally
follow the contours of the mesh base when it
is initially adjusted. We therefore recommend
that you lie down on the mattress while adjust-
ing the positions for the first time.
GB4
_007ZB_3151 BW.pdf - pag.14

4. Use

4.1 Manually adjustable sections

Raise back section
Pull the adjustment cord and lean forward with
the upper part of your body. The back section
will then move up automatically. Release the
cord when you reach the position you want.
Lower back section
Pull the adjustment cord and lean backwards.
The back section will go down. Release the
cord when you reach the position you want.
If necessary, you can adjust the power of the
gas spring yourself (see 4.2).
Foot end
The foot end has six adjustable positions.
Carefully pull on the handle until the desired
position is reached.
To put the foot end into a lower position you
must first pull it up as far as it will go and then
lower it again.

4.2 Adjusting the power of the gas spring

The power with which the back section of the
mesh base is raised and lowered is adjustable.
There are three settings:
1. light (top hole): if you select the 'light' set-
ting, the back section is easiest to push
flat.
2. normal (middle hole): standard setting.
3. heavy (bottom hole): if you select 'heavy',
the back section comes up with extra force.
LET OP !!! Lage resolutie!
November 19, 2007