Relocating Operating Side Of Adjustment Cord - Auping Automat 333 Gebrauchsanweisung

Adjusting the spring tension
1. Lift the back section half way up.
2. Unscrew the plastic notched nut (see fig. 4).
3. Attention: support the back section and
remove the connecting pin (pay attention to
the plastic bearing bush in the eyelet of the
gas spring).
4. Place the eyelet of the gas spring in the
required position. The top hole towards the
mesh results in the lightest adjustment.
5. Press the connecting pin through the lifting
arm and the eyelet of the gas spring (pay
attention to the plastic bearing bush in the
eyelet of the gas spring).
6. Tighten the plastic notched nut (see fig. 5).
_007ZB_3151 BW.pdf - pag.15
4.3 Relocating operating side of
The control ball for your mesh base is on the
right, but it can easily be moved to the left.
1. Untie the knot A from the cord B and
remove the ball C (see fig. 6).
2. Remove the protective tube D from the
cord guide E and slide the tube off the cord
(see fig. 7).
3. Tie a knot in the end of the cord.
4. Pull on the cord at the other side of the
bed.
5. Untie the knot.
6. Pull the cord through the protective tube
(first through the eye, then through the tube).
7. Hook and pull the protective tube over the
cord guide.
8. Push the cord through the smaller hole in
the ball.
9. Tie a knot in the end of the cord.
10. Pull the control ball over the knot.
fig. 4
fig. 5
LET OP !!! Lage resolutie!
adjustment cord
fig. 6
fig. 7
GB5
November 19, 2007