ATLANT 50Y88 Gebrauchsanweisung Seite 6

Shutter
Dispenser
drawer
essive foam-formation, which degrades the washing quality and may cause the Machine failure.
Shutter, in section 2 in accordance with Figs. 15 and 17, is provided for liquid detergent using. Numeral
levels of dosing in ml are applied on the both sides of the shutter.
Shutter with numerals 150, 100, 50 on the face should be installed in 50Y88, 50Y108 Machine, but with
numerals 200, 150, 100, 50 in 60С88, 60С108 Machine.
When installing in pan section 2, the shutter must moved on the guides in lower position freely.
When you are using SDs as powder, take the shutter out of the main wash compartment 2 (Fig. 14). Be
careful not to put any powder into the compartment for special treatment substances
foam may form during rinsing and white spots may appear on the items.
In case of a liquid SD, set the shutter into compartment 2 (Fig. 16) and pour the SD with the account
of the level marks on the shutter.
When choosing optional functions
put it in right before washing.
Any overdosage of special treatment agents in the
and their getting into the neighbouring compartments will degrade the washing quality.
When choosing the program (Spot Removal), put the bleachers into compartment 1 (Fig. 14), and
the bleaching will take place immediately after the main washing.
ATTENTION! When using a bleacher, never set the optional function of pre-washing.
YES
NO
Figure 15
10
Cap Cap
Figure 14
(Fig. 15), otherwise
, place the SD into compartment 1. When using a liquid SD,
compartment (above the level MAX on the cap),
Shutter
Figure 16
To improve the washing quality and protect the Machine from lime sediments, when washing in water
having hardness II or III, it is recommended to use, alongside with SDs, a water softener. It should be added
to the SD into compartment 2 (Fig. 12) according to manufacturer's guidelines.
The water hardness is defined according to Table 2. You may obtain data on your water hardness from
the local water supply entity.
Prior to start washing, close the drawer filled with the SD.
NEVER move out the detergent drawer, when the Machine is working, otherwise water may leak and
spray out of the Machine.
REMOVAL OF CERTAIN SPOT TYPES
Certain spots cannot be removed from items at usual machine washing. Therefore, they must be re-
moved manually before washing in the Machine. First try the process in an unseen place of the item, then
start from the edge of the spot and proceed towards its centre to avoid formation of blotchiness. See below
the removal methods of various spots.
Wax should be scraped off with a rounded object in order not to damage the cloth, then the item is
placed between two sheets of blotting paper and hot-ironed.
Spots from ball pens and felt pens are cleaned by means of soft cloth moistened in ethyl alcohol. Watch
for the spot not to bleed.
Spots of mould are removed at washing with adding of a bleacher into the bleacher tray (Fig. 14), if the
cloth withstands the effect of the bleacher. Otherwise, the dirty spot is moistened with 10-percent solution
of hydrogen peroxide and left for 15 minutes.
Light fabric burns left by an iron are removed in the same way as the mould spots.
Rust is removed by special rustremoving agents. Follow the manufacturer's guidelines.
To remove the chewing gum, rub the cloth with ice, then rub with a force and treat with a piece of
cotton cloth moistened in acetone.
Paint is removed after complete drying. A contaminated spot is wiped with a solvent as indicated in
the paint packing (for example, water, turpentine, trichloroethylene), soaped and washed.
Lipstick spots on cotton and wool are wiped with a cloth moistened in ether, and on silk – in trichloroethylene.
To remove nail varnish (polish), put some blotting paper over the dirty cloth and moisten the spot
with acetone from the backside. By frequently changing the paper, moisten the cloth with acetone, until
the spot disappears.
Spots of vegetable oil or tar (resin) are coated with butter for some time, and then washed off with
turpentine.
Grass spots should be soaped by using diluted bleacher. They are easily removed from wool fabrics by
90-percent alcohol solution.
A cloth with spots of blood should be soaked in cold water with adding salt, and then washed with
household soap.
INTERNATIONAL SYMBOLS FOR TAKING CARE OF TEXTILE ITEMS
When washing program and temperature are selected it is recommended that symbols of care on a label
should be studied so that the goods should not be constrained and bleached in the process of washing.
The goods having the labels with the following symbols should be washed in the machine:
— washing, — delicate washing;
Table 2
Hardness
Water Characterization
Degree
I Soft
II Medium hard
III Hard
Water Hardness in dH Water Hardness in Milli-Mol per Litre
0
0 - 7 Up to 1,3
7 - 14 1,3 - 2,5
14 - 21 2,5 - 3,8
11