Aerial Connection; External Fm Or Am Aerial; Speaker Connection - Sharp SD-CX1H Bedienungsanleitung

Aerial connection

Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS
socket and position the FM aerial wire in the di-
rection where the strongest signal can be re-
ceived.
Supplied AM loop aerial:
Connect the AM loop aerial wire to
the AM and GND terminals. Position
the AM loop aerial for optimum re-
ception. Place the AM loop aerial on
a shelf, etc., or attach it to a stand or
a wall with screws (not supplied).
Note:
Placing the aerial on the stereo system or near the AC power lead and speaker wires
may cause noise pickup. Place the aerial away from the stereo system for better
reception.
Installing the AM loop aerial:
< Assembling >
Black
White
< Attaching to the wall >
Wall
Screws

External FM or AM aerial

Use an external FM or AM aerial if you require better reception. Consult your dealer.
AM loop aerial
Notes:


When an external FM aerial is used, disconnect the supplied FM aerial wire from the FM
75 OHMS socket.


When using an external AM aerial, be sure to keep the wire of the AM loop aerial con-
nected.

Speaker connection

Connect the wire with the black line to the (-) and transparent one to the (+) .
Left speaker Right speaker
Clear
Black line
Caution:


Connect the speaker wires to the speakers first, then to the unit.


Use speakers with an impedance of 6 ohms or more, as lower impedance speak-
ers can damage the unit.


Do not mistake the right and the left channels. The right speaker is the one on the
right side when you face the unit.


Do not let the bare speaker wires touch each other.


Do not stand or sit on the speakers. You may be injured.
External FM aerial External AM aerial
15 m (49 feet)
7.5 m
(25 feet)
Earth rod
3
1 2
ENGLISH
E-10