TERMA TDY Gebrauchsanweisung Seite 17

you can easily read the remaining time left
to the end of the heating cycle to 1/10 (10%)
accuracy. Depending on the preset total op-
erating time (60-90-120-150-180 minutes),
the shortest time indicated by your device
will be 6-18 minutes.
Each LED, first glows continuously for 1/10
of the set time, and for another 1/10 of the
set time, it flashes and then goes out. The
red LED glows constantly throughout the op-
eration time until the unit switches itself off.
Example for default factory setting
(working time = 120 min)
— immediately after switching the device
on, all blue LEDs light up,
— after 12 minutes the last LED starts flash-
ing and after further 12 minutes the LED
goes out.
— Each LED first glows continuously for 12
minutes, then flashes for further 12 min-
utes and goes out and so on until the full
heating cycle time is up and the device
turns itself off.
How to set the operating
temperature
To set the operating temperature of the heat-
ing element:
EN
— briefly press button — the first press
puts the heating element into setting
mode — the red LED goes out and a sin-
gle blue LED flashes, indicating the cur-
rent temperature setting,
— another press on the button will change
the temperature — the corresponding
blue LED flashes and a single beep is emit-
ted (characteristic high pitch sound indi-
cates 40°C setting, the remaining two
temperature settings are indicated by
low pitch sound).
Display of operating temperature 40°C 50°C 60°C
Temperature setting
Each time the temperature setting is changed,
a single, corresponding LED flashes for 3 sec-
onds. After the 3 seconds the heating ele-
ment returns to operation with the new set-
tings applied- the red LED lights up and the
LED display shows the countdown timer.
Please note: During operation, it is possible
to change the temperature any number of
times, setting the new temperature does not
affect the countdown timer. It is possible to
manually turn off the device at any time.
17