TERMA TDY Gebrauchsanweisung Seite 14

5. Check the distances between the indi-
vidual heating element tubes and bend
if necessary.
5 mm
6. Do not switch the heating element on if
it is not fully immersed in radiator heat-
ing medium.
7. Make sure an adequate air cushion is pre-
sent to protect against excessive pressure
build up within the heater (always leave
one of the radiator valves open).
8. When filling the radiator with hot liquid
insure that the liquid temperature does
not exceed 65° C.
9. Follow the subsequent guidelines when
connecting the electrical installation:
a. Brown wire — live connection to the
circuit (L).
b. Blue wire — connect to neutral (N)
14
User manual TDY www.termaheat.pl
10. Before filling the radiator with heating
11. In central heating installation radiator
12. The temperature of the heating agent
2-3 mm
13. For detailed installation hints — see
Notes prior to removal:
1. Before dismantling permanently, discon-
2. Be aware. A radiator filled with liquid
3. Before disassembly, close the appropri-
c. Yellow & green wire — earth con-
nection (PE).
medium, ensure that the heating element
is fitted properly and that it is water tight.
must be fitted with the valves enabling
disconnection of the radiator from the
rest of the system.
in the central heating system must not
exceed 82° C!
the last pages of this manual.
nect the heating element from the mains
and ensure that the radiator is not hot.
can be very heavy. When moving the
radiator, ensure that you take the nec-
essary safety precautions.
ate valves and drain the radiator com-
pletely to avoid causing any damage.