Installing A Shelf In Display Version; Installing A Shelf In Sliding Version - ArteVino OXGIT230NVD Gebrauchsanweisung

Installing a shelf in display version:

To install bottles on a display shelf, proceed as follows:
1. Insert 2 runners in the shelf support strips. For each shelf, position one runner on the right and
one runner on the left (see diagram 1 and 2).
2. Place the shelf in the 2 runners. (see diagram 3)
3. Place a locking dowel in each of the 2 holes located at the front of the shelf, in the upper section.
These pins then fix the shelf with respect to the runner and prevent any unwanted movement.
4. Start by placing bottles in each recess of the back row with the base of the bottle towards the
back (6 traditional Bordeaux bottles).
5. Continue stacking the bottles on the back row
(6+5+6+5 = 22 traditional Bordeaux bottles), ensuring that no
bottles touch the back wall.
6. To display your bottles, place them vertically at the front of the shelf
(maximum capacity : 6 traditional Bordeaux bottles)
7. In display version, the shelf has a maximum capacity of 28
traditional Bordeaux bottles.

Installing a shelf in sliding version:

To install bottles on a sliding shelf, proceed as follows
1. Insert 2 runners in the shelf support strips. For each shelf, position one runner on the right and
one runner on the left. (see diagram 1 and 2).
2. Place the shelf in the 2 runners. (see diagram 3)
3. Place a locking dowel in each of the two holes located at the back of the shelf, in the upper
section. These pins prevent the shelf from sliding all the way out of the cabinet
4. Start by placing bottles in each recess of the back row with the base of the bottle towards the
back.
5. Continue by placing the bottles in the opposite direction on the front
row.
6. A sliding shelf can only hold a single row of bottles (maximum
of 12 traditional Bordeaux bottles).
7. In the case of a mixed layout, for optimal accessibility, we recommend
that you place the sliding shelves in the central section of the appliance.
NEVER PULL OUT MORE THAN ONE LOADED SLIDING SHELf AT A TIME.
NB: Additional information, for the small model only.
The small model is delivered with 2 shelves. 1 shelf fixed on runners + 1 shelf placed on 2 fixed rack support
pins.
To change the latter to sliding or display version,
• Remove the shelf from the cabinet,
• Remove the 2 rack support pins,
• Take the 2 runners supplied with the cabinet,
• Insert the 2 runners in the desired location, in the shelf support strips (see diagram 1 and 2),
• Then follow the installation stages provided in the previous paragraphs.
If you do not have enough bottles to fill your wine cabinet, it is preferable to spread the load over the
entire cabinet rather than placing bottles "all at the top" or "all at the bottom". For optimal performance,
we recommend that you use the cabinet at over 75% of its capacity.
GB
9