Status Lights; Everyday Maintenance Of Your Wine Cabinet - ArteVino OXGIT230NVD Gebrauchsanweisung

Alarms
If the temperature inside the cabinet is 6°C above or below the temperature setting, for over 3 hrs, the
control activates the alarm and the warning light
NB: If you have loaded your cabinet with a large number of bottles, it can take several hours
for your wine cabinet's temperature to stabilise. The warning light
a while then check again. If the alarm warning light does not disappear, contact your retailer.

Status lights:

Compressor 1 : indicates that the compressor is operating. When this flashes, it means that the
compressor is going to start up in a few minutes (technical delay).
Heater 2 : indicates that the heater is operating.
Defrosting cycle 3 : indicates that an automatic defrosting cycle is underway.
Alarm 4 : informs you that there is an abnormally high or low temperature inside the wine cabinet.
The recommended setting range for storing wine is 10°C - 14°C.The default setting is 12°C (ideal maturing
temperature).
However, the temperature may also be set between 9 and 15°C.
Your wine cabinet can be placed in a room with a temperature of 0°C - 35°C.
When commissioning your cabinet, or after significant changes to the temperature setting, it can take
several hours for your wine cabinet to stabilize and display the new desired temperature.
Wait a few days. If the temperature does not stabilise, contact your retailer.

Everyday maintenance of your wine cabinet

Your ARTEVINO cabinet is a tried and tested appliance. The following few operations will allow your
cabinet to perform at its best for many years to come.
1) Regularly vacuum (twice a year) the condenser (black metal grill attached to the back of your wine
cabinet).
2) Once a year, thoroughly clean the inside of your wine cabinet, remembering to unplug it after removing
your bottles (use a gentle cleaning product and water and remember to rinse well).
HUMIDITY
Your cabinet is fitted with an exclusive ARTEVINO system allowing you to recreate inside
your wine cabinet the level of humidity required to effectively seal your bottles' corks. When
installing your cabinet, it is important to pour the equivalent of one glass of water onto the
floor of the cabinet to activate the heat pump process.
appears.
may then appear. Wait
GB
11