Vortice VORT HR 350 AVEL Betriebsanleitung Seite 36

ENGLISH
"Setting No Frost Menu" Page
From "Installer menu" page, you can select "No Frost", in order to join to "Setting No Frost".
Pressing the [ ] key will display:
NO FROST
UN-BALAN.
HEATER
HEAT FORC
From "Setting No Frost Menu" page, you can choose desidered "No Frost functions" in order to keep them Enabled/Not
enabled:
- Un-Balan:
- Heater:
- Heat Forc:
NO FROST
UN-BALAN.
HEATER
HEAT FORC
NO FROST
UN-BALAN.
HEATER
HEAT FORC
NO FROST
UN-BALAN.
HEATER
HEAT FORC
36
when the air external temperature is too cold, if the function is Enabled, motor-fans automatically
start to run, following pre-set ventilation programs. Appliance will try to use different ventilation
procedures that take advantage of extracted air (warm) to self-heating.
ATTENTION: The appliance is default setted with "Un-Balan": Enabled (factory production).
To Activating/deactivating the function, see: "Activating/deactivating the function Un-Balan".
(only in case of installing the Pre-Heater optional)
when the air external temperature is too cold, if the function is Enabled, the Pre-Heater starts to
run, for a certain time. Appliance will try to heat using the electric heater installed on the Fresh air
duct (See Fig. 3, Letter (A)).
ATTENTION: The appliance is default setted with "Heater": NOT Enabled (factory production).
So, in case of Installing Pre-Heater, the Installer have to manually activate the function.
To Activating/deactivating the function, see: "Activating/deactivating the function Heater".
ATTENTION: In case of "Heater" function NOT Enabled, the Pre-Heater will not works, also if
correctly wired.
ATTENTION: In case of NOT Installed Pre-Heater, keeping "Heater" Enabled, will
produce abnormalities on "No Frost" function.
(only in case of installing the Pre-Heater optional)
when installing the Pre-Heater, a "working test" is possible forcing Pre-Hater activation.
In case of "Heat Forc" Enabled, the Pre-Heater will run for 15 seconds;
So after that, the function "Heat Forc" will come back "NOT Enabled".
[ ▲ ]
[ ▲ ]
[ ▲ ]
[ ▲ ]
[ ▲ ]
[ ▲ ]
UN-BALAN
[ ▲ ]
HEATER
Activating / deactivating "Un-Balan" Function
Use keys [▲] and [▼] in order to select
YES
"UN-BALAN":
push the botton [ ]:
[ ] [ ] ]
- select [YES] to activate;
NO
- select [NO] to deactivate.
Activating / deactivating "Heater" Function
YES
Use keys [▲] and [▼] in order to select "HEATER":
push the botton [ ]:
[ ] [ ] ]
- select [YES] to activate;
NO
- select [NO] to deactivate.
Activating / deactivating "Heat Forc" Function
Use keys [▲] and [▼] in order to select
YES
"HEATER FORC":
push the botton [ ]:
[ ] [ ] ]
- select [YES] to activate;
NO
- select [NO] to deactivate.
Pre-set values
YES (enabled)
NO (not enabled)