Installation; Wall Mounting - Vortice VORT HR 350 AVEL Betriebsanleitung

ENGLISH

Installation

NOTE The appliance is not suitable for outdoor installation. The appliance must be installed in accordance with current
safety regulations in the destination country, and with the instructions in this booklet. The appliance must be installed on
an internal surface or wall of the home structurally suited to holding its weight (max. 50 kg).
To mount the appliance, use Brackets kit for Wall mounting (supplied with produtc) or Brackets kit for Suspended floor
mounting (optional). IMPORTANT: The appliance cannot be positioned and secured in place using only adhesives.
Expected mountings
- On wall: using Brackets kit for Wall mounting;
- On suspended floor (on hollow space): using Brackets kit for floor mounting;

Wall Mounting

Fig. 4-5
Verify the minimum distance to the floor: the space must be enought to correclty mount condensate drain siphons (see
paragraph: "Connecting to condensate drain duct").
Fig. 6
Positioning the wall bracket on the wall and marking (on wall) holes positions using pencil.
Important: respecting the hole wheelbase as shown.
Fig. 7
Verify vertical and horizontal alignment between holes.
Fig. 8
On wall, create fixing holes.
Fig. 9
We recommend to mount the appliance tilting it few degrees to the wall.
Tilting don' t have to be excessive, to ensure the correct functioning of the appliance.
Fig. 10
On the wall, fixing lateral brackets using screws (Installer have to choose: screw and dowel depending on the wall type)
Fig. 11
Managing the front panel, remove screws manually using: Torx screw driver, type T25.
IMPORTANT: Don't use drill, but remove screws only manually.
Fig. 12
Removing the front panel.
Fig. 13
Positioning product, having care to verify the correct alignment on wall brackets.
Fig. 14
On the lateral brackets, fix the front bracket using screws + washers (supplied with product).
Fig. 15
Mounting the front panel.
Fig. 16
Managing the front panel, apply manually the screws, using: Torx screw driver, type T25, torque 1,0 N/m.
MPORTANT: Don't use drill, but apply screws only manually.
26