Remote Controls - Elettro TIG 2510 AC/DC Betriebsanleitung

edited and edit them.
• Weld, even briefly.
• Briefly press the selector U until the desired program is
displayed.
• Hold down the U button until the save is confirmed
(program symbol changes from flashing to steady).

4. REMOTE CONTROLS

The following remote controls may be connected to adjust the
welding current for this welding machine:
Item 570008 Foot control (used in TIG welding)
Item 535805 TIG UP/DOWN torch.
Item 535807 TIG UP/DOWN water cooled torch.
Item 530330+ltem 570006 (used in MMA welding)
Item 363307 Connection to simultaneously connect the torch
and the pedal control.
Item 570008 may be used in any TIG welding mode with this
accessory.
Remote controls that include a potentiometer regulate
the welding current from the minimum to the maximum
current set via the knob T.
Remote controls with UP/DOWN Iogic regulate the
welding current from the minimum to the maximum.
The remote control settings are always active in the PL
program, while they are not active in a saved program.
14