Hama AV-1200 AIR Bedienungsanleitung Seite 31

Receiver Introduction
Front & Back Panel
1. Power LED
2. IR Sensor
3. TV2 Source Key
4. 2.4GHz Patch Antenna
5. Stereo Audio Output Port
6. AV/VCR Input/Output Port
7. TV2 Input/Output Port
8. Power Input Port
Shows On/Off status of the 2.4GHz RF transmission function.
Receiving IR signal from the remote controller.
Press this key to turn on the 2.4GHz RF transmission function.
This also turns on the 2.4GHz transmission function on transmitter
(TV1) side at the same time.
When the 2.4GHz LED is lighting, pressing this key allows the change of
TV2 signal source.
Hold this key for 3~5 seconds to turn off the 2.4GHz RF transmission
function when the 2.4GHz LED is lighting. This also turns off the 2.4GHz
transmission function on transmitter (TV1) side at the same time.
Stereo audio output. Same with TV2's sound output.
This allows COMPOSITE or RGB signal input or COMPOSITE signal output.
It is recommended to connect VCR-type (player and recorder) devices
to this port
This allows simultaneous COMPOSITE or RGB signal output and
COMPOSITE signal input.
Connect the included power adaptor to this port.
– 31 –