TDS SoundMaker Bedienungsanleitung Seite 24

Playback
Open the cassette deck with the ST/EJ button (see Figure 1).
Put a cassette into the deck with the open side of the cassette
facing down and the required cassette side facing the front (side 1
or A; side 2 or B).
Close the cassette deck.
Press the PLAY button.
Note: To stop the cassette, press the ST/EJ button (Stop/Eject).
Press this button again to open the cassette deck. Now
remove the cassette.
Recording
Note: As with all other cassette recorders, this device will only
record onto cassettes with intact delete-protection tabs.
Put the recording cassette into the cassette deck.
Press the PAUSE button.
Press the REC button.
Release the PAUSE button to start the recording.
Note: The recording can be interrupted briefly by pressing the
PAUSE button. To stop the recording, press the ST/EJ
button.
Finding a particular place on the tape
Before recording or playback, press the RESET button to set the
COUNTER to 000 (see Figure 2).
Make a note of particular places on the tape by using the counter.
These positions can easily be found again by using fast forward
(F.FWD button) or rewind (REW button).
Figure 2
24
COUNTER RESET
0 0 0
Operation Manual
Status 11/03