Automatic Picture Quality Adjustment Function (For Pc 2 Only); Turning Off The Display Automatically - Sony MFM-HT95 Bedienungsanleitung

Automatic picture quality
adjustment function
When the display receives an input signal, it
automatically adjusts the picture's position and
sharpness (phase/pitch), and ensures that a clear
picture appears on the screen.
The factory preset mode
When the display receives an input signal, it automatically
matches the signal to one of the factory preset modes stored in the
display's memory to provide a high quality picture at the centre of
the screen. If the input signal matches the factory preset mode, the
picture appears on the screen automatically with the appropriate
default adjustments.
If input signals do not match one of the factory
preset modes
When the display receives an input signal that does not match one
of the factory preset modes, the automatic picture quality
adjustment function of this display is activated to ensure that a
clear picture always appears on the screen (within the following
display frequency ranges):
MFM-HT75W
Horizontal frequency: 28–69 kHz
Vertical frequency: 48–85 Hz
MFM-HT95
Horizontal frequency: 28–86 kHz
Vertical frequency: 48–85 Hz (resolution<1280 × 1024),
48–75 Hz (resolution=1280 × 1024)
Consequently, the first time the display receives input signals that
do not match one of the factory preset modes, the display may
take a longer time than normal to display the picture on the screen.
This adjustment data is automatically stored in memory so that
next time, the display will function in the same way as when the
display receives the signals that match one of the factory preset
modes.
If you adjust the phase, pitch, and picture position
manually
For some input signals, the automatic picture quality adjustment
function of this display may not completely adjust the picture
position, phase, and pitch. In this case, you can set these
adjustments manually (page 25). If you set these adjustments
manually, they are stored in memory as user modes and
automatically recalled whenever the display receives the same
input signals.
32
(for PC 2 only)
Turning off the display
automatically
(for
only)
You can set the display to turn off automatically after a
predetermined period of time (15, 30, 45, 60, or 90 minutes).
Press the button on the remote control repeatedly.
Each time you press the button, the period of time changes as
follows:
To cancel the Sleep timer
Press the button repeatedly until "Off" appears.
Tips
• If you turn the display off, and then turn it on again, the Sleep
timer is set to off.
• While the Sleep timer is activated, the 1 (power) indicator
lights up in red.
TV/VIDEO 1/VIDEO 2
O f f
1 5 m i n
3 0 m i n
4 5 m i n
6 0 m i n
9 0 m i n