Storage; Possible Faults - ATIKA LSH 3000-2 Originalbetriebsanleitung


Please proceed as follows to preserve the functioning
ability of your garden vac.
 Remove dust and dirt with a cloth or a brush.
 Do not clean the machine with running water or high-
pressure cleaners.
 Do not use solvents for the synthetic parts (petrol, alcohol,
etc.) as these can damage the synthetic parts.
Cleaning the bag
Empty the bag every time after it has been used.
To remove the collection bag, pull the locking lever (B) to
the rear.
 Shake the bag thoroughly.
 Turn it inside out and brush the bag out thoroughly.
 Wash the bag when extremely soiled or at least once a
year, by hand in mild soap suds.

If the zip fastener is stiff, rub dry soap into the zip.
For your own safety, regularly check the bag for any
signs of damage. Always replace a damaged bag
immediately.
Before each fault elimination:
 Switch off device.
 Wait for standstill of the device.
 Pull out mains plug.
Problem Possible cause
Motor won't start  No mains power (power failure)
 Connection lead defect
 Motor or switch defect
 Collecting bag not mounted or not mounted
Material is not sucked  Machine is clogged or blocked
in properly (reduced  Bag too full
vacuuming power)  Speed setting too low (only for garden vacs with
 Extension cable too long, or cross-section too
Machine works with
 Internal fault
interruptions
 ON-Off-switch defect

In case of further faults or inquiries please contact your local dealer.

Possible faults

correctly
fully variable speed control)
small. Socket too far away from main
connection, and cross-section of connection
lead too small.

Storage

 Store devices that are not in use in a dry locked place
protected against frost and outside the reach of children
and unauthorized persons
 Before a longer storage observe the following in order to
prolongate the service life of the machine and to guarantee
a smooth running operation:
 thoroughly clean the machine
 Check the machine for perfect condition to ensure a
safe use of it after a longer period of storage
Remedy
 Check fuse (10 A)
 Replace lead or have lead checked (electrician)
Never use defect lead
 To solve the problem, contact the manufacturer
or an authorised company (see customer service
list)
 Attach the collection bag correctly
 Eliminate the blocking, call the service if required
 Empty bag
 Adjust to higher speed
 Extension cable at least 1.5 mm
m long. Cross- section of at least 2.5 mm
longer cables.
 Contact the costumer service
, maximum 25
2
in
2
17