Assembly; Start-Up; Working With The Garden Vac; Mains Connection - ATIKA LSH 3000-2 Originalbetriebsanleitung

Assembly

Please observe the enclosed assembling
instructions!
Connect the leaf sucker to the power supply system
only after having finished the complete assembly.
Assembling the suction tube
Insert the rear suction pipe (7) and the rear blowing
pipe (8) into the unit, and screw both to the unit.
Insert the axle of the wheel (10) through the holder and
turn the wheel (10a) on the axle.
Insert the double pipe (9) into the rear pipes and screw
everything together
Fixing the handle
Plug the front handle (4) on the handle holder and
fasten it with the star grip screw (5).
Fixing the collecting bag
First hook the collecting bag (13) into the front lug of
the frame (A).
Fold the collecting bag (13) back until it audibly
engages in the frame holder
Hook the eyelet (C) into the retainer of the rear suction
pipe.

The device is not equipped with a safety lock. The
device cannot be started without attaching or
correctly attaching the collection bag.
Fixing the carrying strap
Hook the carrying strap (14) into the eyelet (D)
provided on the unit.

Start-up

 Check that the machine is completely and correctly
assembled.
 Before using the shredder, make sure each time that
 the supply / extension cable for damages (cracks, cuts
or the like) or ageing (brittleness).
Do not use defective supply or extension
cables.
there are no damage at the machine

all screws are tight

the collecting bag shows no signs of wearing or quality

deterioration


Mains connection

 Compare the voltage given on the machine model plate
with the mains voltage and connect the machine to the
relevant and properly earthed plug.
 Only use connection cables with sufficient diameters.
 Do not use any defective connection cables.
 Connect the machine via a 30 mA fault current safety
switch.
 Use connecting or extension cables up to a length of 1.5 m
featuring a core cross section of at least 25 mm²

Fuse protection: 10 A

Mounting of the extension cable

Plug the female connector of the extension cable on the
male connector (12) of the device.
Thread the extension cable (F) through the pull relief
device (E) as a loop and hang it up.

Make sure that the extension cable has enough free
motion.

Switching on/off

The On/Off switch is integrated in the handle.
Hold the switch pressed to start the leaf sucker
The leaf sucker stops automatically when you release
the switch.
Do not use any device where the switch cannot be
switched on and off. Damaged switches must be repaired
or replaced immediately by the customer service.

Working instructions

Before starting any work read and understand
 the safety notes,
 following additional instructions on how to
work with this machine.
Carry out the following checks before startup and
regularly during work: Observe the relevant sections in
the operating instructions:
Before start of work
 Check the device before each use: for possible damages
 Wear your safety gear Make sure to have a safe and tidied
up work area. Remove from the working area objects
which might be thrown off (e.g. stones).
 Do not work in bad weather conditions (e.g. rain, risk of
lightning).
 Make sure that:
 no other persons or animals stay within the working
area,
 you can always step back without any barriers,
 you have always a secure standing position.
 handles and mountings are dry and clean.
 The following is recommended before starting the
blowing/suction:
 use a rake and broom to loosen dirt
 slightly wet dusty areas
 Never point the suction/blow tube to yourself or other
person or animals. Never blow objects in the direction of
people of animals.
15