Atexor P-Ex WLAN-DC-A Bedienungsanleitung Seite 38

•
Omni-directional antenna IP68 (ANT-24-2-O)
Water-proof, short, screw-in antenna for the 2.4 GHz frequency range with an antenna gain
of 2 dBi and a length of 9.2cm. The antenna is connected to the access point via a 150 cm
extension cable.
•
3 meter extension cable (CAB-RSMA/F-RSMA-M-3) from the RP-SMA socket to RP-
SMA plug
Connects the antenna's RP-SMA sockets to the RP-SMA plug of the access point via a 3
meter extension cable made of low-loss H-155 cable. Designed for use with the following an-
tennas: ANT-24/58-3/5-I and ANT-24-7-I.
•
5 meter extension cable (CAB-RSMA/F-RSMA/M-5) from the RP-SMA socket to RP-
SMA plug
Connects the antenna's RP-SMA sockets to the RP-SMA plug of the access point via a 5
meter extension cable made of low-loss H-155 cable. Designed for use with the following an-
tennas: ANT-24/58-3/5-I and ANT-24-7-I X.
•
Extension cable (CAB-RSMA-/M-N/M-5) from the RP-SMA socket to N plug
Connects the antenna's N-sockets to the RP-SMA plug of the access point via a 5 meter ex-
tension cable made of low-loss H-155 cable. Designed for use with the following antenna:
ANT-24-8-O.
•
PoE injector
Allows you to connect the power supply (24V) via the ethernet cable. The PoE injector allows
you to connect the redundant power supply via the ethernet cable.
•
Open-ended RJ45 configuration cable (CAB-OPEN-RJ45-CONFIG)
Enables you to connect to and configure the P-Ex WLAN via a PC.
34