Transmission Signal Of Rp-Sma Plug Connector Of The P-Ex Wlan; Assembling The P-Ex Wlan's Antennas - Atexor P-Ex WLAN-DC-A Bedienungsanleitung

3.5.

Transmission signal of RP-SMA plug connector of the P-Ex WLAN

RP-SMA plug connector -
Ex i
The frequency is 2.4GHz/5GHz
The output level is ≤ 312mW
Only ANT-24/58-3/5-I, ANT-24-7-I, ANT-24-8-O, ANT-24-2-O type antennas may be used
with the P-Ex WLAN. Always use two antennas of the same type.
3.6.

Assembling the P-Ex WLAN's antennas

Keep the protective caps on the RP-SMA connectors until the P-Ex WLAN
access point is fully assembled.
The antennas of the WLAN access point are attached by screwing the
ends into the RP-SMA sockets
Make sure the P-Ex WLAN is equipped with RP-SMA sockets. RP stands for reverse polari-
ty, meaning that the plug and socket are swapped. So the socket contains the male pin and
the plug has the female socket that goes over it. Please note this when acquiring antenna
cables.
28
Assignment
RP-SMA 1
RP-SMA 2
SMA
Plug Socket
Transmission signal 1
Transmission signal 2
RP-SMA
Plug Socket