Installing The Advanced Gateway 2330 In An Equipment Rack - Avaya Advanced 2330 Vorschriften

1. Attach a mounting bracket to each side of the router.
2. Insert screws through the holes in the mounting brackets into the wall location.
The Advanced Gateway 2330 has two internal, non-removable fans. Allow sufficient clearance
for maintenance and for proper airflow. Keep cable bundles clear of the intake and exhaust
vents.

Installing the Advanced Gateway 2330 in an equipment rack

Required tool: Phillips screwdriver for attaching brackets to the switch.
• The Advanced Gateway 2330 requires one rack unit (1.75 inches, 44.45 millimeters)
• The rack must be bolted to the floor, and braced if necessary.
• The rack must be grounded to the same grounding electrode used by the power service in
the area. The ground path must be permanent and must not exceed 1 ohm of resistance
from the rack to the grounding electrode.
• Ensure that the mounting brackets are firmly installed on the chassis.
• Ensure that you have appropriate antistatic materials.
Risk of equipment damage
Always wear an antistatic wrist strap connected to an ESD jack to prevent damage from
electrostatic discharge.
Follow these steps to install the Advanced Gateway 2330 in an equipment rack:
Regulatory Information
The following figure illustrates the mounting bracket position for a wall installation.
Electrostatic alert:
Installing the Advanced Gateway 2330 in an equipment rack
July 2010 13