Aerfast ANS21131 Betriebsanleitung Seite 7

! ALWAYS USE THE PROPER FITTING FOR THE TOOL
Only MALE pneumatic type air connectors should be fitted to the
tool, so that high pressure air in the tool is vented to atmosphere as
soon as the air line is disconnected.
NEVER install FEMALE quick disconnect couplings on the tool.
Female couplings will trap high pressure air in the tool when the air
line is disconnected, leaving the tool charged and able to drive at
least one fastener.
! DO NOT EXCEED THE MAXIMUM RECOMMENDED AIR
PRESSURE
Operate the tool only at the recommended air pressure. Do not
exceed the maximum air pressure marked on the tool. Be sure the
air pressure gauge is operating properly and check it at least twice a
day.
Never use any bottled air or gases such as oxygen to operate the
tool since they could cause the tool to explode.
! KEEP THE TOOL CLEAN AND LUBRICATED
Clean the tool at least daily and lubricate as required. Never operate
a dirty or malfunctioning tool.
! USE ONLY RECOMMENDED PARTS AND FASTENERS
Use only parts and fasteners specifically designed and
recommended for use in the tool and for the work to be done. Using
unauthorized parts and fasteners or modifying the tool in any way
creates dangerous situations. Replace all missing parts-refer to tool
schematic for correct placement and part number.
Failure to follow any of the above instructions could result in
severe personal injury to tool user and bystanders or cause
damage to tool and property.
SAFETY INSTRUCTIONS
DANGER
-5-