Operator Troubleshooting - Aerfast ANS21131 Betriebsanleitung

Disconnect the tool when performing repairs or clearing jams
PROBLEM
Fasteners will not drive completely into
wood.
Fasteners penetrate properly during
normal operation, but won't drive fully at
faster speeds.
Fasteners drive too deeply into wood.
Fastener jams in nose of tool.
Tool skips during operation-no fasteners
are driven from time-to-time.
Tool operates, but no fasteners are
driven.
Air leaks at cap when tool is connected
to air.

OPERATOR TROUBLESHOOTING

CAUTION
Adjust work contacting element (retract
length) increase air pressure (do not
exceed 120 psi).
Increase air flow to tool-use larger air
lines (3/8 inch ID minimum).
Adjust work contacting element (extend
length). Reduce air pressure.
Open front guide latch, release jammed
fastener, and close latch securely).
Check magazine for proper fasteners.
Magazine follower should slide freely.
Clean as needed to remove debris.
Make sure correct fasteners are being
used. Use fasteners that meet
specifications only.
Increase air flow to tool-use larger air
lines (3/8 inch ID minimum).
Adjust work contacting element where
available.
Check magazine for proper fasteners.
Fasteners should slide freely with no
follower pressure.
Open front guide latch or loosen
magazine knob and check for jams or
debris in nose area. Clear as necessary.
Increase air pressure (do not exceed
120 psi).
Tighten cap screws.
-16-
CORRECTIVE ACTION
.