Aerfast ANS21131 Betriebsanleitung Seite 10

Air pressure at the tool must never exceed 120 psi.
Your pneumatic tool comes ready for immediate use and can be
installed by following these steps:
i. SAFETY-All tool operators and their immediate supervisors must
become familiar with the operator safety instructions before
operating the tool. The instructions are on page 2 of this manual.
ii. Included with each tool are one copy of this Safety and Maintenance
manual and one copy of the Tool Schematic. Keep these
publications for future reference.
iii. The Plastic cap in the air inlet of the tool must be removed before
the male air fitting is installed. The fitting must be a male pneumatic
type that discharges the air from the tool when the air line is
disconnected.
iv. Install a filter/regulator/lubricator unit with a gauge as close as
practical to the tool, preferably within ten feet. Refer to the Air
Systems section of this manual for air hose requirements and
lengths. In general, no other special installation is required.
v. If the operator is working at a bench or table, it is usually best to run
the air line underneath the bench. A small tray under the benchtop
can hold the fastener supply and the tool when not in use.
vi. If this tool does not work when is it is first connected, do not try to
make repairs. Call your local service center immediately.
Air pressure at the tool must never exceed 120 psi.
DANGER
DANGER
-8-
TOOL INSTALLATION