Aerfast ANS21131 Betriebsanleitung Seite 6

! OPERATE THE TOOL ONLY ON A WORKPIECE
The tool should be operated only when it is in contact with the
work piece. Even then you should be careful when fastening thin
material or working near the edges and corners of the work piece
since the fasteners may drive through or away from the work
piece.
! DO NOT DISABLE OR REMOVE THE WORK CONTACTING
ELEMENT
This tool is equipped with a safety mechanism, called a work
contacting element, to help prevent accidental firing. Never
tamper with, disable or remove the work contacting element. Do
not use the tool unless the work contacting element is working
properly. The tool could fire unexpectedly.
! DISCONNECT THE TOOL WHEN NOT IN USE
Always disconnect the tool from the air line when it is not used or
when you leave the work area. The tool should never be left
unattended because people who are not familiar with the tool
might handle it and injure themselves or others.
! CARRY THE TOOL ONLY BY THE HANDLE
Always carry the tool by the handle only. Never carry the tool by the
air hose or with the trigger depressed since you could drive a
fastener unintentionally and injure yourself or someone else.
! DO NOT WEAKEN THE TOOL HOUSING
The tool housing is a pressure vessel and should never be
weakened by having your company's name, area of work or
anything else stamped or engraved into its surface.
! DISCONNECT THE TOOL WHEN PERFORMING REPAIRS
AND CLEARING JAMS
Never attempt to clear a jam or repair a tool unless you have
disconnected the tool from the air line and removed all remaining
fasteners from the tool.
SAFETY INSTRUCTIONS
-4-