Safety Instructions - Aerfast ANS21131 Betriebsanleitung

SAFETY FIRST
These safety instructions provide information necessary for safe
operation of pneumatic tools. DO NOT attempt to operate the tool until
you read and understand all safety precautions and manual
instructions.
! WEAR EYE AND HEARING PROTECTION
Always wear hearing and eye protection devices, including side
shields when operating or working in the vicinity of a tool.
! THE TOOL MUST BE USED ONLY FOR THE PURPOSE FOR
WHICH IT WAS DESIGNED
Do not throw the tool on the floor; strike the housing in any way or
the tool as a hammer to knock material into place.
! NEVER ENGAGE IN HORSEPLAY WITH THE TOOL
The tool is not a toy so do not use it like one. Never engage in
horseplay with the tool or point it at yourself or any person, even if
you think it is not loaded.
! NEVER ASSUME THE TOOL IS EMPTY
Check the magazine for fasteners that may be left in the tool.
Even if you think the tool is empty or disconnected never point it at
anyone or yourself. Unseen fasteners could fire the tool.
! NEVER CLAMP THE TRIGGER IN A LOCKED OR OPERATING
POSITION
The trigger of the tool must never be tampered with; disabled or
clamped in a locked or operating position since this will cause the
tool to driver a fastener any time the work contacting element is
depressed.
! DO NOT LOAD FASTENERS WITH THE AIR LINE
CONNECTED
When loading fasteners into the tool sure you disconnect the air
line and that you do not depress the trigger or work contacting
element.

SAFETY INSTRUCTIONS

-3-