Electronic Control Panel; Time Of Day - SUPREME OXYLINE Montageanleitung

ELECTRONIC CONTROL PANEL

SETTING THE TIME AND DAY OF THE WEEK
Setting the time should take place only in case when the
appliance is connected to the power supply (the first start-
up) and in case when the reset occurred during longer
power outage. In such case, after restarting the controller
the figures indicating the time are flashing.
Step 1: Press the button „SET CLOCK".

TIME OF DAY

12:00
LPM 0
SET CLOCK REGEN
Step 2: SETTING THE TIME (HOUR): Set proper figure of
„hour" by pressing the buttons „+" or „-".
Pressing the button „NEXT" causes going to the next
parameter. You can go back to the previous step anytime
by pressing the button „REGEN".
TIME HOUR
16:00
SET
SET CLOCK
REGEN
Step 3: SETTING THE TIME (MINUTES): Set proper figure of
„minutes" by pressing the buttons „+" or „-". Pressing the
button „NEXT" causes going to the next parameter. You
can go back to the previous step anytime by pressing the
button „REGEN".
TIME MINUTES
16:23
SET
SET CLOCK
REGEN
Step 4: SETTING THE PROPER DAY OF THE WEEK: Set the
day of the week by pressing the buttons „+" or „-". Pressing
the button „NEXT" causes going to the next parameter.
You can go back to the previous step anytime by pressing
the button „REGEN".
WED
+
-
NEXT
The properly programmed controller should display the
information:
+
-
NEXT
Step 1: Press the buttons „NEXT and „+" at the same time.
+
-
NEXT
CURRENT DAY
WED
SET
SET CLOCK REGEN
RETURN
TO THE MAIN
DISPLAY
TIME OF DAY
16:23
LPM 0
SET CLOCK
REGEN
Current water consumption expressed in l/min.
Current time
Current day of week
APPLIANCE PROGRAMMING
SET CLOCK REGEN
+
-
NEXT
WED
+
-
NEXT
+
-
NEXT
11