SUPREME OXYLINE Montageanleitung Seite 14

ELECTRONIC CONTROL PANEL
START-UP: SETTING THE TIME (MINUTES): Set proper
figure of „minutes" by pressing the buttons „+" or „-".
Pressing the button „NEXT" causes going to the next
parameter. You can go back to the previous step anytime,
by pressing the button „REGEN".
ALARM BUZZER START
SET
SET CLOCK REGEN
COMPLETION: Similarly, set the time when the alarm is to
switch off.
Pressing the button „NEXT" causes going to the next
parameter. You can go back to the previous step anytime,
by pressing the button „REGEN".
ALARM BUZZER END
SET
SET CLOCK REGEN
Step 11: Setting the display operation - By pressing the
buttons „+" or „-" set the mode of the display operation.
OFF mode - if the user does not take any action, the display
switches off after several minutes.
ON mode - causes that the display is switched on all the
time.
You can go back to the previous step anytime, by pressing
the button „REGEN". Pressing the button „NEXT" causes
the return to the main display.
LIGHT NORMALLY
SET
SET CLOCK REGEN
14
+
6:00
-
NEXT
+
22:00
-
NEXT
+
OFF
-
NEXT
RETURN TO THE
MAIN DISPLAY
GENERAL INFORMATION
During the operation, the controller may show one of the
five screens. By pressing the button „NEXT" you can switch
over between the alternative screens.
The first screen always indicates the current time.
The second screen indicates the amount of water
expressed in litres per minute, which has flown through
(has been filtered) by the system.
The third screen informs whether the holiday mode is
activated (the holiday mode may be activated or
deactivated from this level). The holiday mode is
responsible for starting up the regeneration in case when
the time regeneration is switched off. Then, although
sufficient amount of water does not flow through the
system, the system goes into the regeneration mode to
flush periodically the filter bed.
The fourth screen shows the volume of water remaining to
the time of next regeneration
The fifth screen shows the number of days remaining to
the time of next regeneration.
If the regeneration is initiated on a given day, the message
„REGENERATION TODAY" appears on the screen.
REGENERATION TODAY
16:23
LPM 3250
SET CLOCK REGEN
REGENERATION MODE
At the moment the system goes into the regeneration
mode, the screen displays the information on the current
stage of the regeneration, as well as the amount of time
remaining to its completion.
BACKWASH-AIR
SET
SET CLOCK REGEN
WED
+
-
NEXT
+
10%
8
SEK
-
NEXT