Electronic Control Panel - SUPREME SOFT Montageanleitung

COMMISSIONING
STEP 1. Adjust the residual hardness of the water that
leaves the appliance, by means of the adjusting screw,
incorporated in the 'outlet' valve of the factory bypass:
STEP 1A. To raise the residual hardness: turn the screw
counter clockwise; usually 1 turn corresponds to a residual
hardness of ±4 °f (±2 °dH), 2 turns to ±8 °f (±4 °dH).
STEP 1B. To reduce the residual hardness: turn the screw
clockwise.

ELECTRONIC CONTROL PANEL

Symbol
Button
SCROLL
UP
DOWN
POWER-UP
After power-up the display will show the installed
software version for a period of 5 seconds; f.e.:
EZ3P5f EZ3PB r14
STEP 1. Manually initiate a regeneration, by pressing
the scroll
STEP 2. Leave the appliance in this position; the
countdown timer will countdown to 0 sec and start
a regeneration.
In the event of a power failure, the program will remain
stored in the NOVRAM during an undefined period, while
the SuperCap will maintain the correct time of day during
a period of several hours; consequently, in case
of prolonged power failure, the time of day might
not be maintained; if this happens, the time of day will
be reset to 8:00 when the power supply is re-established,
while the indication will flash, indicating that the time
of day needs to be set.
When the power failure occurs during the execution
of an automatic regeneration, the appliance will
immediately return to the service mode; when the power
supply is re-established, the appliance will resume
Function
the regeneration.
to advance to
the next parameter
to increase the value
of the parameter
In the event of a timer failure, the display will show
to decrease the value
the message:
of the parameter
If powering off/on the appliance doesn't solve this
problem, professional service is required.
PERFORM REGENERATION
button; the display will show:
Regen in 10 sec
POWER FAILURE
®
TIMER FAILURE
Service Required
9