SUPREME OXYLINE Montageanleitung Seite 8

INSTALLATION
WITH 3-VALVE BYPASS SYSTEM
(not included).
3
4
1. mains water supply (untreated water).
2. inlet of appliance (untreated water).
3. outlet of appliance (treated water).
4. house/application (treated water).
STEP 1. Install the 3-valve bypass system.
STEP 2. Screw the connection kit with nuts onto the
connections of the appliance (2 & 3); make sure to install
the gasket seals. Tighten the nuts firmly by hand.
STEP 3. Connect the 3-valve bypass system to the adaptors
on the in (2) and out (3) connections.
STEP 4. Connect the mains water supply to the inlet
of the 3-valve bypass system (1).
STEP 5. Connect the house/application to the outlet
of the 3-valve bypass system (4).
8
2
1
STEP 1. Screw up the hose on the connection (1), make
sure that the hose is equipped with the stiffening insert at
its end.
STEP 2. Run the drain hose to the drainage system and
connect it to the stand pipe assuring sufficient air gap. This
drain line operates under pressure, so it may be installed
higher than the appliance.
DRAIN
- We recommend the use of a stand pipe with air trap.
- To prevent backflow from the drainage system into
the appliance, always make sure to have an air gap
between the end of the drain line and the drainage
system itself; as a rule of thumb, the air gap should
be minimum 2x the diameter of the drain line.
- Lay-out the drain hoses in such a way that pressure
loss is minimized; avoid kinks and unnecessary
elevations.
- Make sure that the sewerage system is suitable
for the rinse water flow rate of the appliance.
1