Cameo AURO SPOT Z 300 Bedienungsanleitung Seite 11

DEVICE SETTINGS (Settings)
You can access the options menu by pressing MODE. Using the
ground) and confirm with ENTER.
This will take you to the sub-menu for setting the following sub-menu options (select using
value or status using and , and confirm with ENTER):
Settings (bold = factory setting)
Display
= Flip Display
Rev
Display = Display Backlight
Operating mode for DMX
DMX Fail =
signal interruption
DimCurve = Dimmer Curve
Pan Angle = Pan Angle
Pan Rev = Pan Reverse
Tilt Rev = Tilt Reverse
PWM freq = LED PWM Frequency
Fan = Sets fan control
Feedback = Position correction
Mov Automatic blackout when
=
Blackout head moves
Test = Function test
Factory
= Reset to factory settings
Reset
Reset = Reset the motors
and control keys, now select the "Settings" menu option (dark back-
Off Display does not rotate
On Display rotates by 180° (e.g. when installed overhead)
Deactivates after approx. 30 seconds of inactivity
Off
On Permanently on
Hold Last command is kept
Blackout Activates blackout
Linear Light intensity increases linearly with DMX value
"Exp Light intensity can be finely adjusted at lower DMX values and
(exponential)" broadly adjusted at higher DMX values
"Log Light intensity can be broadly adjusted at lower DMX values
(logarithmic)" and finely adjusted at higher DMX values
Light intensity can be finely adjusted at lower and higher DMX
S-curve
values and broadly adjusted at medium DMX values
540 Pan angle 540°
630 Pan angle 630°
Off Pan movement direction does not reverse
On Pan movement direction reverses
Off
Tilt movement direction does not reverse
On Tilt movement direction reverses
800 Hz / 1200 Sets the LED PWM frequency
Hz / 2000 Hz /
3600 Hz / 12 kHz /
25 kHz
Auto Automatic fan control
Silent Extra quiet fan with reduced brightness, if required
On Automatic position correction activated
Off Automatic position correction deactivated
Off No blackout when head moves
On Blackout when head moves
Off Stops the function test
Step-by-step function test of the LED and all motors (pan, tilt,
On
gobo, etc.)
Reset to factory settings:
Reset?
Confirm with ENTER, cancel with MODE
Pan&Tilt Reset the pan and tilt motors
Reset all head motors (color wheel, gobo well, prism, etc.)
Head
All Reset all motors
and , confirm with ENTER, change the
11