Installation; Maintenance & Servicing; Environmental Conditions; Equipment Disposal - OHAUS Vortex series Bedienungsanleitung

i
nstallation
Upon receiving the Ohaus Vortex Mixer, check to ensure that no damage has
occurred during shipment. It is important that any damage that occurred in
transport is detected at the time of unpacking. If you do find such damage the
carrier must be notified immediately.
After unpacking, remove the protective coverings from the feet and place the
Vortex Mixer on a level bench or table, away from explosive vapors. Ensure that
the surface on which the unit is clean and free of dust. Always place the unit on
a sturdy work surface.
The Vortex Mixer is supplied with a power cord that should be plugged into a
properly grounded outlet. If the supplied power cord does not meet your needs,
please use an approved power cord that suits local codes and electric supply.
Replacement of the plug must be made by a qualified electrician.
m & s
aintenance ervicing
The Vortex Mixer is built for long, trouble-free, dependable service. No lubrication
or other technical user maintenance is required. The unit should be given the
care normally required for any electrical appliance. Avoid wetting or unnecessary
exposure to fumes. Spills should be removed promptly. DO NOT use a cleaning
agent or solvent on the front panel which is abrasive or harmful to plastics, nor one
which is flammable. Always ensure the power is disconnected from the unit prior
to any cleaning. If the unit ever requires service, contact your Ohaus representative.
e c
nvironmental onditions
Operating Conditions: Indoor use only.
Temperature: 4 to 40°C (39 to 104°F)
Humidity: 20% to 85% relative humidity, non-condensing
Altitude: 0 to 6,562 ft. (2000 M) above sea level
Non-Operating Storage:
Temperature: -20 to 65°C (-4 to 149°F)
Humidity: 20% to 85% relative humidity, non-condensing
Installation Category II and Pollution Degree 2 in accordance with IEC 664.
e d
quiPment isPosal
This equipment must not be disposed of with unsorted waste. It is
your responsibility to correctly dispose of the equipment at life-cycle-
end by handing it over to an authorized facility for separate collection
and recycling. It is also you responsibility to decontaminate the
equipment in case of biological, chemical, and/or radiological
contamination, so as to protect the persons involved in the disposal
and recycling of the equipment from health hazards.
For more information about where you can drop off your waste of equipment,
please contact your local dealer from whom you originally purchased this
equipment. By doing so, you will help to conserve natural and environmental
resources and you will ensure that your equipment is recycled in a manner that
protects human health.
EN
2