Mounting Accessories - Ferm RSM1018 Originalbetriebsanleitung

Indicates electrical shock hazard.
Wear a dust mask. Working with wood,
metals and other materials may produce
dust that is harmful to health. Do not
work with material containing asbestos!
The number of revolution of the machine
can be electronically set.
Safety instructions
The machine must not be damp and must not be
operated in a wet environment. Wear protective
gloves and sturdy footwear.
Hold power tool by insulated gripping
surfaces, when performing an operation where
the cutting accessory may contact hidden
wiring or its own cord.
Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
Do not saw materials containing
asbestos!!!
• Wear protective goggles when working with
materials which produce large amounts of
chips.
• Wear a protective mask when sawing other
fibrous materials.
• Remove adjusting keys and wrenches before
turning the tool on.
• Secure your workpiece with clamps.
• Move machine towards the workpiece only
when switched on.
• Always hold machine with both hands and
ensure that you have a safe footing while
working.
• The machine may be operated only with the
foot plate mounted. When sawing, the foot
plate must always rest on the workpiece.
• Incorrect handling may damage the machine.
Therefore always comply with the following
instructions.
• Use only sharp saw blades in perfect
condition; replace cracked, distorted or blunt
saw blades immediately.
4
• Machine should only be switched on with
blade installed
• Do not attempt to stop the saw blade with
lateral pressure after switching off.
• Only use genuine accessories.

3. MOUNTING ACCESSORIES

Fitting a saw blade
Fig. B
The machine is equipped with a quick fit system.
• Turn the clamping ring (2) of the saw blade
holder as far to the left as possible and hold it
there.
• Place the saw blade in the blade holder.
• Let go of the clamping ring.
• Make sure when changing the saw blade that
the blade holder is free of material debris (such
as splinters of wood or metal).
• Before use, always check that the saw blade is
securely fixed.
Removing the saw blade
• Turn the clamping ring of the saw blade holder
as far to the left as possible and hold it there.
• Remove the saw blade from its holder.
• Let go of the clamping ring.
Adjustment of the guide shoe
Fig. A
When the blade loses its sharpness at some
sections of it's cutting edge, reposition the
foot plate to use a sharp, unused portion of its
cutting edge. Besides this, the foot plate can
also be used for adjusting maximum saw depth,
especially useful when sawing in hollow walls.
• The footplate can be extended by loosening
the two footplate mounting screws (5) using
the 4 mm hexagon key and then pulling the
footplate out to the required length.
Ensure the footplate adjustment screws are
secure before resuming work.