OSRAM DALIeco BT control Bedienungsanleitung Seite 2

 DALIeco BT control / Operating instructions
Application and function
The DALIeco BT Control allows control of DALI luminaires with normal white or tunable white light sources according to DALI device type
8 (DT8) via smart phones with Android or IOS operating system. Dimming and switching of the lighting is also possible by directly con-
nected standard push buttons with push to make contacts or push button connected via an OSRAM DALI push button coupler.
If OSRAM DALI sensors are connected an additional daylight- and presence dependent control or an automatic dimming and switch of
after a predefined delay time can be achieved.
Subsequently only plug & play functions that can be used without smart phone are discribed. All further functions are explained
in detail within the smart phone App directly.
1. Operation without sensors
Switch the lighting ON and OFF
Make a short press to the push button.
Dimming the lighting brighter or darker
Make a long press to the push button, dimming direction changes with every button press.
Storing a fixed Switch On Level (= Memory-Wert)
• Switch on the lighting and dim to the desired level.
• Push the button briefly two times (=double click). Storage of the switch on level is confirmed by a two times blinking.
Deleting a fixed Switch On Level
• Switch off the lighting.
• Push the button briefly two times (=double click). Deletion of the switch on level is confirmed by a two times blinking. Subsequently
the last level before switch off will be used as switch on level.
2. Operation with sensors
When sensors are connected light will be switched on automatically when the detection area is entered, if a set point for the daylight
dependent regulation is stored, automatic switch on will only take place, if artificial light is required. 15min after leaving the detection
area, the light will be dimmed and switched off. If a set point is stored, light will be regulated according available daylight after switch
on by push button or sensor. If the amount of daylight exceeds the set point value for some minutes, the light will be switched off and
at diminishing daylight automatically on again; if persons are still within the detection area.
Switch the lighting ON and OFF manually
Make a short press to the push button. In case of a set point is stored, a manual switch on by the push button will automatically start
the daylight dependent regulation.
Dimming the lighting brighter or darker
Make a long press to the push button, dimming direction changes with every button press. The daylight dependent regulation is tempo-
rarily interrupted until the next switch on via push button or sensor.
Storing a set point for the daylight dependent regulation
Dim the light level to the desired brightness manually and store the brightness by two subsequent short presses (= Double click). The storage
process takes approx. 5s. Within this period the light level is set to 100% first, then temporary switches off, the process is completed
when the light switches on again. To avoid false measurements, no persons should be below the sensor within the storage process period.
Hint: Storage of a set point should be done with no ambient light or at a low ambient light level.
Deleting the set point for the daylight dependent regulation
Switch off the light by a short push and then delete the set point by two subsequent short pushes (= Double click). Deletion is confirmed
by a two times blinking.
3. Control by smart phone
OSRAM BT CONTROL
Via the integrated bluetooth interface an
OSRAM BT CONTROL
additional control by smart phone is possible.
Please install the corresponding APP.
IOS 8.4
Android 4.x
OSRAM GmbH
Berliner Allee 65
86153 Augsburg
Germany
2
www.osram.com