Operating Elements And Connections; Safety Notes - Monacor TXA-140US Bedienungsanleitung

All operating elements and connections de -
scribed can be found on page 2.
1 Operating Elements
and Connections
1 Eyebolts to attach the shoulder strap
2 Battery compartment
3 Display for the receiver; to indicate the channel
adjusted when the receiver is switched on
When a radio signal is received, the green LED
on the display lights up.
4 Channel selector switches for the receiver
5 On-off switch and volume control for the
receiver
6 Indication CHARGE DISPLAY: power indica-
tion, battery status indication and charge indica-
tion
After switching on the speaker system, the red
segment of the indication lights up as a power
indication.
In case of battery operation
the number of green segments lighting up
indicates the state of charge of the battery. If
no green segment lights up any more, the
battery is almost discharged and should be
recharged as soon as possible.
In case of mains connection
the green segments start flashing when the
battery is being recharged and light continu-
ously when it has been fully recharged.
7 Control ECHO to mix an echo effect to the
microphone signal at the input MIC IN (8) and
the microphone signal received via wireless
transmission
8 Microphone input MIC IN (6.3 mm jack, unbal.)
9 Input AUX IN (3.5 mm jack, unbal.) to connect a
unit with line output, e. g. CD player, cassette
recorder, radio
10 On-off switch for the unit and control for the
overall volume
11 Output MIX OUT (3.5 mm jack, unbal. ) to con-
nect another active speaker system or a
recorder; the control MAIN VOL (10) has no
effect on the output level
12 Jack DC IN to connect the power supply unit
provided
1.1 MP3 player with IR remote controller
13 IR sensor for the remote control signals
S and S
14 Buttons
title
to go to the next or previous
15 Button / S S (on the unit) or S S (on the remote con-
troller) to change between replay and pause
The button on the unit
keeps flashing rapidly: replay mode
keeps flashing slowly:
lights continuously:
16 Button EQ / REPT (on the unit)
Buttons EQ and REP (on the remote controller)
– Briefly press the button EQ / REPT or the but-
ton EQ to change between five equalizer set-
tings.
– To change between the replay modes
SINGLE (repeat of the title)
RANDOM (random replay)
ALL (repeat of all titles)
OFF (normal replay mode)
keep the button EQ / REPT pressed or briefly
press the button REP.
17 Button I to stop the replay and to return to the
beginning of the title at the same time
18 On-off switch and volume control
19 Display
a symbol for the device
b time already played of the title
c symbol for the replay mode
d length of the title
e file name of the title
f number of the title
g total number of titles
20 Slot for an SD card
21 USB port to connect a USB mass storage
device, e. g. USB flash drive, USB hard disk
with separate power supply
22 Numerical keys for direct title selection
23 Button VOL- and VOL+ to adjust the volume

2 Safety Notes

The units (active speaker system and power supply
unit) correspond to all relevant directives of the EU
and are therefore marked with
WARNING The power supply unit uses danger-
ous mains voltage. Leave servicing
to skilled personnel only. Inexpert
handling or modification of the power
supply unit may result in electric
shock.
Please observe the following items in any case:
G
The power supply unit is suitable for indoor use
only. The active speaker system is also suitable
pause mode
stop mode or
no device connected
.
GB
9