Monacor TXA-140US Bedienungsanleitung Seite 10

for outdoor use if it is protected against precipita-
GB
tion and humidity. The shoulder bag supplied with
the unit will ensure sufficient protection against
humidity.
G
Always protect the units against dripping water and
splash water, high air humidity and heat (admissi-
ble ambient temperature range: 0 – 40 °C).
G
Do not place any vessel filled with liquid on the
speaker system or the power supply unit, e. g. a
drinking glass.
G
Do not operate the active speaker system and
immediately disconnect the mains plug of the
power supply unit from the socket
1. if the active speaker system, the power supply
unit or the mains cable is visibly damaged,
2. if a defect might have occurred after a unit was
dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the units must be repaired by skilled
personnel.
G
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the plug.
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
G
No guarantee claims for the units and no liability
for any resulting personal damage or material
damage will be accepted if the units are used for
other purposes than originally intended, if they
are not correctly connected or operated, or if they
are not repaired in an expert way.
G
Important for U. K. Customers!
The wires in this mains lead are coloured in
accordance with the following code:
green/yellow = earth
blue = neutral
brown = live
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
1. The wire which is coloured green and yellow
must be connected to the terminal in the plug
which is marked with the letter E or by the earth
symbol , or coloured green or green and
yellow.
2. The wire which is coloured blue must be con-
nected to the terminal which is marked with the
letter N or coloured black.
3. The wire which is coloured brown must be con-
nected to the terminal which is marked with the
letter L or coloured red.
Warning – This appliance must be earthed.
10
Never put used batteries or defective recharge-
able batteries in the household waste; always
take them to a special waste disposal, e. g. col-
lection container at your retailer.
If the units are to be put out of operation
definitively, take them to a local recycling
plant for a disposal which is not harmful to
the environment.
3 Applications, Accessories
The audio amplifier system TXA-140USB is a
portable speaker system with amplifier (active
speaker system). It is equipped with an MP3 player
to replay USB mass storage devices and SD cards
and features a UHF PLL receiver (16 channels in the
range 863 – 865 MHz). From the MONACOR prod-
uct range, the wireless microphone TXA-140HT is
ideally suited for this amplifier system.
Power is supplied from a mains socket via the
power supply unit provided or via the integrated
rechargeable lead gel battery which allows mains-
independent operation. An integrated charger will
recharge the battery. Thus, the unit is ideally suited
for mobile PA applications at events, lectures, etc.
For PA application of larger zones, set up several
active speaker systems TXA-140USB to receive
and reproduce the signal of a single wireless micro-
phone. However, it is also possible to connect
another active speaker system to the audio output
MIX OUT.
The system is supplied with a practical shoulder
bag and a shoulder strap.
4 Setting Up / Transporting the Active
Speaker System
Place the active speaker system as desired or
preferably mount it onto a stand at a height of
1 – 1.5 m above the ground. For stands with a 9 mm
3
( ⁄ ") thread, a threaded jack is provided on the
8
lower side of the active speaker system. For
speaker stands with a standard tube diameter of
36 mm, the MONACOR stand adapter EBH-48 is
available.
For transport, e. g. in case of guided tours, use
the shoulder strap or the shoulder bag provided.
Attach the strap to the eyebolts (1). For operation
inside the shoulder bag, put the active speaker sys-
tem into the bag in such a way that the sound from
the speaker is radiated through the mesh side. To
access the operating elements and connections,
open the lateral flap of the bag (hook and loop fas-
tener).