Preparation And Taking Into Operation - Reiner jetStamp 790 MP Kurzanleitung

jetStamp 790/790 MP
jetStamp 792/792 MP

1. Preparation and Taking into Operation

1.1. Commissioning jetStamp 790/790 MP
Only connect the device to the PC after the 790 PCset easy software has been installed.
Installation of the 790 PCset easy software installs the required USB drivers. The USB
drivers are automatically recognised and loaded when the device is connected to the
computer. The device driver installation fails if the device is connected without the
790 PCset easy software being installed.
The batteries must be completely charged before using the stamp for the first time.
This takes about 14 hours.
Inserting rechargeable batteries
Open the battery compartment
f
Check for correct polarity and insert the batteries.
f
Close the battery compartment
f
Charge batteries
Put the jetStamp 790 in the charging station
f
Connect the Mini-USB socket
f
USB cable.
Connect mains unit to the mains.
f
Batteries are charged when the green charging control light
f
Charging condition is displayed by the symbol
f
Troubleshooting
The following message appears in the display
"EMPTY BATTERY - NO IMPRINT POSSIBLE".
The batteries have not been recognised by the system.
Press any key.

The display
Unallowed inputs may have been made.
Press the reset button

1.2. Commissioning jetStamp 792/792 MP
Only connect the device to the PC after the 790 PCset easy software has been installed.
Installation of the 790 PCset easy software installs the required USB drivers. The USB
drivers are automatically recognised and loaded when the device is connected to the
computer. The device driver installation fails if the device is connected without the
790 PCset easy software being installed.
15

2
on the back of the stamp.
2
.
Fig.
A D
+

7
of the charging station
12
is dark or lines appear.
3
.
Fig. B
4
with the locking tab
4
with the mains unit with the
in the display
12
after inserting batteries
8
first.
6
is lit.
12
after a few minutes.