GreenWorks 25147 Bedienungsanweisung Seite 8

INSTALLING ThE MULChING PLUG
■ Lift and hold up the rear discharge door.
■ Grasp the mulching plug by its handle and insert it at a
slight angle, as shown.
■ Push the mulching plug securely into place.
■ Lower the rear discharge door.
SETTING BLADE hEIGhT
When shipped, the wheels on the mower are set to a low-
adjust the cutting position to the height best suited for your
lawn. The average lawn should be between 38 mm and 51
mm during cool months and between 51 mm and 70 mm
during hot months.
To adjust the blade height
■ To raise the blade height, grasp the height adjustment
lever and move it toward the back of the mower.
■ To lower the blade height, grasp the height adjustment
lever and move it toward the front of the mower.
OPERATION
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
Always wear eye protection. Failure to do so could
result in objects being thrown into your eyes resulting
in possible serious injury.
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
Always inspect mower for missing or damaged parts
and blade for damage, uneven, or excessive wear prior
to use. Using a product with damaged or missing parts
could result in serious personal injury.
English (Original Instructions)
WARNING
WARNING
WARNING
WARNING
■ Do not tilt the lawn mower when starting the engine
or switching on the motor, unless the lawn mower has
to be tilted for starting. In this case, do not tilt it more
than absolutely necessary and lift only the part which
is away from the operator.
■ Do not start the engine when standing in front of the
discharge chute.
■ Do not put hands or feet near or under rotating parts.
Always keep clear of the discharge opening.
USING ThE CORD RETAINER
This lawn mower is equipped with a cord retainer in order
to prevent the extension cord from disconnecting from the
power cord while the mower is in use. The cord retainer
hangs from the cord guide bar.
NOTE: Do not plug the extension cord into the outlet until
it has been connected to the cord retainer and plugged
into the mower.
To use the cord retainer:
■ Fold the extension cord in order to forming a tight loop
near the retainer.
■ Push the loop through the bottom hole in the retainer.
■ Slide the loop over the retaining clip, and pull down
until the cord is secured.
STARTING/STOPPING ThE MOWER
To start the motor:
■ Plug the mower into an approved outdoor extension
cord.
■ Press and hold the start button.
■ Pull the bail switch upward to the handle to start the
mower and release the button.
To stop the motor:
■ Release the bail switch.
The protector (it's a device that is calibrated to open the
motor circuit upon reaching a certain temperature/current
but requires both cool down below the calibration point
and removal of power for resetting of the protector) in
the mower helps to stop the mower if blade is stuck or
overload occurs.
When the protection happens, the operator should release
the bail switch and pull the plug immediately, then restart
the mower after at least 1 minute. The operator will wait
for longer time and the mower can't run if it is restarted
within 1 minute.
16