Troubleshooting - GreenWorks 25147 Bedienungsanweisung

TROUBLEShOOTING

Problem
Motor refuses to start
Garden product functions
intermittently
Garden product leaves ragged finish
and/or Motor labours
Blade not rotating while garden
product switched on
Excessive vibrations/noise
If these solutions do not solve the problem contact your authorised service dealer.
English (Original Instructions)
Possible cause
Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Grass too long
Motor protector has activated
Extension cable damaged
Internal wiring of garden product
damaged
Motor protector has activated
Height of cut too low
Cutting blade blunt
Possible clogging
Blade fitted upside down
Cutting blade obstructed
Blade nut/bolt loose
Blade nut/bolt loose
Cutting blade damaged
19
Solution
Turn power on
Use another socket
Inspect cable, replace if damaged
Replace fuse
Increase height of cut and tilt garden
product to reduce starting load
Allow motor to cool and increase
height of cut
Inspect cable, replace if damaged
Contact Service Agent
Allow motor to cool and increase
height of cut
Increase height of cut
Replace the blade
Check underneath the garden
product and clear out as necessary
(always wear gardening gloves)
Refit blade correctly
Switch off garden product Clear
obstruction (always wear gardening
gloves)
Tighten blade nut/bolt
Tighten blade nut/bolt
Replace the blade