Getting Started - Klarstein Tomahawk 3.OT Bedienungsanleitung

EN
32

GETTING STARTED

Preparation
• You will need a gas cylinder and proper regulators under the gas pressure to
operate this gas grill. The regulators should be comply with EN16129 with current
version and national regulation.
Installation
• After purchasing your gas cylinder you will then be ready to set it up with your gas
grill.
• Check all the parts, and make sure no part is missing. If there are any parts missing,
please contact customer service.
• For assembly you will need a suitable screwdriver and spanner.
• Only use tools that are intact and suitable for the job at hand.
• Select a suitable place to set up the appliance. The appliance is positioned firmly
on a flat, sufficiently large surface area. Make sure the inlet and the outlet regulator
are correct and suitable for the cylinder valve and appliance.
• If the regulator is used outdoors, make sure that it is protected from atmospheric
agents.
• For connecting the gas cylinder, you will need a suitable spanner.
• When connecting the flexible tube, make sure it is not twisted.
How to conenct a gas cylinder
• When changing the gas cylinder which shall be carried out away from any source
of ignition. Position the gas cylinder at left side of your gas grill, should not be
placed inside BBQ, keeping in mind that the gas cylinder must be kept away from
heat and in a safe position.
• When ready to use your gas grill insert the regulator into the gas cylinder valve and
tighten firmly.