Using The Product As Intended; Safety Notes; Contents; Symbols And Their Meaning - Märklin 72752 Bedienungsanleitung

1. Using the Product as Intended

This turnout control box is for controlling the Märklin my world
74492 turnout mechanism.

2. Safety Notes

Make sure you read the following safety notes before using
this Märklin product for the first time.
• IMPORTANT! Sharp edges and points required for operation.
Danger of choking due to detachable small parts that may be
swallowed.
• This product may only be used indoors.
• Do not store this product in direct sunlight or areas with
extreme swings in temperature or high humidity.
• Visually examine the switched mode power pack and its
power cord at regular intervals (depending on the frequen-
cy with which you use it to run the trains), at least once a
week, to make sure it is not damaged. Do this examination
with the power pack unplugged from the household
current. If you have the least suspicion of damage, do not
use the power pack again until it has been repaired by the
Märklin Repair Department.
2.1 Important Notes
• The instructions for use are a component part of the
signal control box and must therefore be kept in a safe
place as well as transferred along with the signal control
box to third parties.
• This signal control box may only be used in conjunction
with the 66361/66365 switched mode power pack and the
194548 Base Station.
8
• Please, see your authorized Märklin specialty dealer for
repairs or spare parts.

3. Contents

1 x Signal control box
1 x Connecting cable
2 x Labels
1 x Set of instructions for use
1 x Warranty card

4. Symbols and Their Meaning

indicates adherence to all basic safety and health
requirements.
Toy for use with a transformer
max.
Rated voltage
22 V ~

5. Setup and Connections

Setup may be done only under the supervision of adults.
Unplug the switched mode power pack from the household
current in order to prevent damage during setup. Do not plug
the switched mode power pack in the wall outlet again until
you are finished with all of the wiring.
• Plug the cable that comes with the signal control box into
the 4-pin socket (left or right) (see Fig. 1 that follows)..
• After that, insert the other plug into the 4-pin socket on
the 194548 Base Station (see Fig. 1 that follows).