Troubleshooting - Pioneer SGX-CA900 Bedienungsanleitung

Troubleshooting

EN
If you have problems with your device, check the following items. If you cannot find a solution to your problem here, contact your
dealer.
■
Will not power up.
The battery is not charged.
The temperature of the device may be too high or low.
■
The battery goes dead soon after it is charged or the message "Shutdown" appears and power turns off
when the [START/STOP] button is not pressed.
The battery charge is low.
The built-in battery is dead.
The screen brightness setting is too high.
■
The operation button or the touch panel is not responding.
There are numerous possibilities for non-operation.
■
The touch panel is not responding.
The touch panel cannot sense your input.
The touch panel is locked.
■
You do not know how to initialize.
■
Sensor information is not displayed.
The sensor is not paired.
The sensor battery is almost empty.
Or the battery is not loaded in the sensor correctly.
56
Cause
Cause
Cause
Cause
Cause
-
Cause
Solution
Charge the battery.
Ü Charging the Device (page 6)
Wait until the device is within standard operating temperature
ranges.
Ü Charging the Device (page 6)
Solution
Charge the battery.
Ü Charging the Device (page 6)
Replace the built-in battery.
A high screen brightness setting can cause the battery to run
down quickly. To conserve battery power, use a lower screen
brightness setting.
Ü Changing Screen Brightness (page 26)
Solution
Push the [START/STOP] button and [LAP] button at the same
time for more than 10 seconds to try the forced reset. After the
forced reset, set the [Date & Time] (page 12).
The log data and setting data will not be deleted by a forced
reset as it may cause a malfunction.
Solution
The device has a resistive touch panel. Resistive touch
panels require a stronger touch than capacitive touch panels.
Press and hold the (MENU) button to unlock. The
message appears when it locks.
Solution
Tap [System]-[Setting Manager]-[Initialize] from the home
screen to initialize.
Ü Initialize (page 51)
If you initialize, the ride log data will be deleted. Save the data
to a PC before initialization.
Solution
Check that the sensor is paired to the device properly. If you
use the pedaling monitor sensor SGY-PM900, refer to the
User's Manual of the SGY-PM900 and Installation Manual.
Replace the battery with a new one.
Or check to make sure that the battery is correctly loaded in
the sensor.
For details about how to replace and load the sensor battery,
refer to the sensor user's manuals.