Logging; Bike Select; Bike Edit - Pioneer SGX-CA900 Bedienungsanleitung

Cyclocomputer Settings
EN

Logging

Use the settings below to configure the logging operation.
Settings marked with an asterisk (*) are initial factory defaults.
Setting Item
Auto Pause/Resume
Trigger Threshold
Logging Interval

Bike Select

Use the setting below to change the bike being used.
Setting Item
(Bike name)
• If the bike is changed, the registered sensor setting will also change automatically. When you change the bike, make sure that the
sensor is connected with the device.

Bike Edit

Use the settings below to register and edit bike information.
• Correctly configured bike information is required in order to obtain accurate data.
• The device can have up to six bikes registered to it. You can use the procedure under "Bike Select" (
registered bikes.
• The riding distance and time of the bike are added automatically after this setting.
Setting Item
Bike 1,
Bike 2,
Bike 3
Bike 4,
Bike 5,
Bike 6
46
Enable* or disable Auto Pause/Resume.
Select the check box to enable Auto Pause/Resume.
Ü Auto Pause/Resume Settings (page 23)
Specify the Auto Pause/Resume speed threshold value.
Specify the logging interval.
Specifying [Auto] causes the logging interval to be adjusted automatically within a range 1 to
10 seconds in accordance with riding speed.
• Auto
• 1 sec*
• 3 sec
• 5 sec
• 10 sec
Change the bike being used. The device can have up to six bikes registered to it.
Sensors Edit sensors connected to bike.
Ü Sensor Settings (page 48)
Wheel Circumference Specify the bike wheel circumference.
Total Distance Bike Specify the bike riding distance.
Total Time Bike Specifies total time ridden on each bike.
Name Specify the name of the bike.
Weight Specify the weight of the bike.
Crank Length Specify the crank length.
Saddle Height Specify the saddle height.
Saddle Setback Specify the saddle setback.
Stem Length Specify the stem length.
Handlebar Position Specify the handlebar position.
Frame Size Specify the frame size.
Chainrings Specify the chain ring size.
Sprocket Specify the number of sprocket teeth.
Wheel Specify the wheel type.
Description
Description
Ü page 46) to change to one of the
Description