Installation - Omnitronic SDP-1 Bedienungsanleitung

5. INSTALLATION

■ Install the player on a plane surface or in your rack. For 19" (483 mm) rack installation, 2 units are
required. It should be a double-door rack where the front panel and the rear panel can be opened. The rack
should be provided with a cooling fan. When mounting the player into the rack, please make sure that there
is enough space around the device so that the heated air can be passed on. Steady overheating will damage
your device. You can fix the player with four screws M6 in the rack. Be aware that fastening the device with
four screws on the front panel is not enough. In order to ensure safety, additional fastening by using ground
and side bars is necessary.
■ Prior to making or changing any connections, switch off the SD card player and the units to be connected.
■ Connect the stereo outputs AUDIO OUTPUT L/R via RCA cables to the line inputs on the mixer or
amplifier (the figure shows the connection to the MX-540). Make sure that the right/left occupation (plug
color red/white) is the same at both devices.
■ The player mechanisms of the SDP-1 can be started or set to pause via mixer with fader start function.
Use the supplied mini jack cables to connect each output FADER START to the corresponding input on the
mixer.
Please note that the fader start function only works with compatible mixers (e.g. MX-540, EX-840,
CM-860). Mode of operation: The mixer has to be connected via a 3.5 mm jack with the SDP-1. For starting the
playback, the jack's positive pin (tip) is to be connected with the audio mass via a short impulse. For pausing the
playback, the jack's negative pin (sleeve) is to be connected with the audio mass via a short impulse. The mixer has to
be equipped with a switch, button or fader that will connect the tip with the audio mass of the SDP-1 for starting the
playback and the sleeve for pausing the playback when the respective channel is activated.
■ Connect the SDP-1 player to the mains.
29/39 00032609.DOC, Version 1.0