Error Message Hb 10 Basic - IKA HB 10 basic Betriebsanleitung

Error message HB 10 basic

Any malfunctions during operation will be identified by lighting up the red signal lamp "Error".
Proceed as follows in such cases:
Error message Cause
"Error" signal lamp - Safety circuit temperature set too low
lights up - Dry run
- Controller set higher than safety circuit
"Error" signal lamp - Faulty controller
lights up again after
reset, also in case of
max. adjusted
safety temperature
limit
If the actions described fail to resolve the fault or another error code is displayed then take one of the following steps:
- Contact the service department
- Send the device for repair, including a short description of the fault.
22
Effect Correction
Device off - Let device cool down
- Reset
- Check settings and correct if necessary
- Top up tempering medium
Device defect - Contact the service department.