Klarstein 10030846 Bedienungsanleitung Seite 20

6. Press the TIMER button a sixth time until the back digits start flashing. Use the [+] and [-] buttons to set the minutes (e.g.
47).
7. Press the TIMER button again to save the time you set and turn the power on. The digital display shows the ambient
temperature. You can now set the weekly timer.
Set the day timer
Press TIMER button on remote control, you can set day timer. Press [+] and [-] button to set the day time. Press [+] to set the
time to 30 (min) - 1H - 2H - 3H ... up to 8H - 00. Press [-] to set the time to 8H - 7H - 6H ... down to 30 minutes.
Note: While making any settings relevant to timer setting, the screen will also display the timing icon. When the timer
setting has only 99 seconds left, the digital tube will show the seconds left.
Set the week timer
Press this TIMER button 3-5 seconds to set the weekly timer. Press the TIMER button for 5 seconds, and the display panel
will show [ON] and [MON] , while the digital display showing [...].
Weekly timer set, start from Monday, for example setting Monday: Monday [ON] status - Monday [OFF] status - Thursday
[ON] status - ... Sunday [OFF] status.
1. Press TIMER button the first time, through the ‚ ‚ button to set the start working time on Monday, while the display
board [ON] and [MON] will be flashing at the same time. Firstly, set the hour, the first two digital of the tube
showing hours, you can press [+] and [-] button to set the hour.
2. Press TIMER button the second time to set minutes. Ten minutes is consider to be a unit and you could press [+] and
[-] button to adjust minutes (from 10, 20 - 50 - 00 minutes).
3. Press TIMER button the for the third time, you can set the power-off working time on Monday. The [ON] icon will be
disappear and at the same time the [OFF] icon will flash on. [MON] icon will not disappear. First, you can set hours
by pressing plus and minus button. The first two digit will display hours.
4. Press TIMER button the fourth time to set the minutes, you can adjust the minutes by pressing plus and minus button.
You will finish setting the Monday timer setting after four time setting operation.
5 Press the TIMER button again you can setting the on-off situation on Tuesday. The operation method is same as
Monday.
Note: When you finish to set the whole week, the digital tube will show the ambient temperature. This indicate the
setting have been finished.
Disabling the timer on a certain day of the week
If you do not want to set the on-off timer on a certain day of the week, you need to press the timer key continuously for four
times to skip this day.
Example: you do not need to set on-off status on Tuesday. When the Monday timer setting is finished, press the timer
setting key, then you could set Tuesday. [ON] and [MON] will disappear. Instead, [ON] and [TUE] will lit up. At the same
time, the first two digits begin to flash on the screen. In this case you should not press [+] or [-] button to set time. Press the
TIMER button again. At the same time, the second two digits begin to flash on the screen. In this case you should not press
[+] or [-] button to set time. Press the TIMER button again. The [ON] icon on the display board will disappear while [OFF]
20