Warnings/Error Messages - HANSGROHE PHARO EL40 26945000 Montageanleitung

Warnings/Error Messages

Warnings/Error Messages
In addition to normal information, e.g. water tem-
perature, the K4 control also displays warnings and
error messages. Warnings and error messages can
be distinguished as follows:
Warnings (e.g. A01) signal unusual operating
statuses. Although the operating status concerned
can somewhat restrict shower performance, you can
still take showers in most cases.
Error messages (e.g. F01) also signal abnormal
operating statuses. Here shower operation remains
fully interrupted – as against warnings – until the
malfunction has been cleared. This prevents any
hazards to the user.
List of possible warnings/error messages on the K4 display:
Warnings
A01 Thermostat motor current too low
A03 Thermostat motor current too high
Resistance of thermostat potentiometer too low
A05
A07 Resistance of thermostat potentiometer too high
A11 Improbable values from temperature sensor
A12 Teaching aborted
Error messages
F01 Keyboard 1 not responding
F02 Keyboard 2 not responding
F03 Extension module not responding
F09 Controller error
F14 Motor current, motor temperature too high
nominal temperature >42°C
36
What do I do when a warning or error
message is displayed?
Note the letter/number combination shown on the
display. Pass the number combination and, if possi-
ble, the associated cause which is explained in the
following list on to your sanitary dealer as soon as
possible. The dealer will then be able to react
quickly to the malfunction.
Possible causes
Cable break, plug connection
Sluggish control unit
Cable break, plug connection motor
Cable break, plug connection motor
Cable break, plug connection, temperature sensor defective
Water supply insufficient, pressure differences, temperatures
Possible causes
Defective keyboard
Defective keyboard
Defective extension module
Defective basic unit
Sluggish control unit